Camera Status Indicators
An overview of the status indicator lights on the OptiTrack Ethernet cameras.
Overview
PrimeX and SlimX series cameras have status lights on the front and back of the cameras.
PrimeX Status Ring Light Color
The PrimeX Series cameras have a front mounted status ring light to indicate the state of the Motive software and firmware updates on the cameras. The following table lists the default ring light color associated with the state of Motive.
Bottom Left Display Values
On every PrimeX and SlimX camera there is an additional display in the bottom left corner of the camera.
How to Troubleshoot E Codes
Codes with the E prefix are error codes that are typically caused by network issues, such as a bad Ethernet cable or a bad port on the switch. These issues can often be resolved by unplugging the camera from the switch and plugging it back in or restarting the switch to reset the entire network. Replace the Ethernet cable or plug the camera into a different port or into a different switch, if the reset doesn't work.
If the error code persists after changing the cable and the port, contact OptiTrack Support.
Changing Status Ring Light
Some of the colors of the Status Ring can be customized. To do so, go to Settings > General. Click the color box next to the status you would like to change. This will open a color picker window where you can choose a solid color or choose multi-color to oscillate between colors. You also have the ability to save a color to your color library to apply it to other statuses.
Turning off Aim Assist Button LED
The Aim Assist button on the back of the camera is illuminated with a built-in LED. Once the system is setup and all the cameras are focused and aimed correctly, you may prefer to turn this off.
Go to Settings > General.
In the Aim Assist section, toggle the Aiming Button LED setting to off.

Back Ring Light Colors
The PrimeX and SlimX Series cameras also have a status light on the back panel to indicate the state of the camera.
Firmware Updates
The camera should not be unplugged during a firmware reset or firmware update. Give the camera time to finish this process before closing Motive.
If a camera doesn't update its firmware with the rest of the cameras, it will not get loaded into Motive. This could be caused by miscommunication between the camera and the switch when loading in numerous cameras. If this occurs, wait for all cameras that are updating to finish, then restart Motive. The cameras that failed to update will now update.
Last updated
Was this helpful?
























