Quick Start Guide, specifications, and additional information about the Wired CinePuck.
The Wired CinePuck is OptiTrack’s purpose-built tracking tool for Virtual Production and Broadcast studios. An Ethernet-connected device, the Wired CinePuck allows extended detection ranges and increased positional precision while eliminating dropped frames caused by external RF noise. Additionally, OptiTrack’s Motive software allows you to fuse the Wired CinePuck’s IMU data with its optical data to provide the highest quality object tracking possible.
For more information on how to use CinePucks for Virtual Production, please see our InCamera VFX page for detailed instructions.
For information on the CinePuck, please visit the page.
Attach the Wired CinePuck to the movie camera using either:
1/4"-20 threads 6X for standard tripod mounts
3/8"-16 threads 1X for optional ARRI-style anti-twist mount
Connect the Wired CinePuck to a PoE or PoE+ switch on the camera system network using a shielded Cat 6 or Cat 6a Ethernet cable.
Once connected, the Wired CinePuck will receive power from the switch.
When connected to the OptiTrack system, the Wired CinePuck IMU is shown in the . Select it to view its properties in the Properties pane.
To use a Wired CinePuck in Motive, it must first be an asset. Please see the page for instructions on creating a , and the page for detailed instructions on pairing the IMU.
Once the Wired CinePuck rigid body is created, it will be available in the , where you can also select it to view the IMU-related properties in the Sensor Fusion section of the .
Diffuser Posts are optional accessories that improve the trackability of the Wired CinePuck in situations where the built-in flat markers may become occluded.
The Diffuser Post kit includes 1" and 2" posts, eleven of each, along with a spudger tool for removing the flat markers.
The Wired CinePuck has a small slot next to each flat marker, as shown in the image, below.
Gently insert the corner of the spudger into the slot of the flat marker you wish to remove and pry the marker from the Wired CinePuck casing.
Once the flat marker is removed, place the marker post you wish to attach over the LED until you feel the magnet snap it into place.
The following specifications apply for active IR LEDs on the Wired CinePuck:
850 nm IR spectrum
11 LEDs
LED Output Standard
Illuminations synchronized with camera exposures
Optical Detection Distance:
Top Diffusers (only): 24m
All Diffusers: 18m
Use only fully-shielded Cat 6 or Cat 6a cables. Please see the Ethernet Cabling Requirements section of the Cabling and Load Balancing page for more information on Ethernet cables and network configuration.
