Timeline Frame Range Indicator
Scrubber: Current frame.
Green: Working frame range.
Yellow: Selected frame range.
There are two different modes in Motive: Live mode and Edit mode. You can toggle between two modes from the Control Deck or by using the (~) hotkey.
Live Mode
The Live mode is mainly used when recording new Takes or when streaming a live capture. In this mode, all of the cameras are continuously capturing 2D images and reconstructing the detected reflections into 3D data in real-time.
Edit Mode
The Edit Mode is used for playback of captured Take files. In this mode, you can playback, or stream, recorded data. Also, captured Takes can be post-processed by fixing mislabeling errors or interpolating the occluded trajectories if needed.
Located on the right corner of the control deck, the status monitor can be used to monitor specific operational parameters in Motive. Click on up/down arrows to switch the displayed status. You can also click on the status monitor to open a popup for displaying all available status.
The following status parameters will be available:
Residual
Average of values of all live-reconstructed 3D points. This is available only in the or in the .
Data
Current incoming data transfer rate (KB/s) for all attached cameras.
Point Cloud
Measured latency of the point cloud reconstruction engine.
Rigid Body
Measured latency of the rigid body solver.
Skeleton
Measured latency of the skeleton solver.
Software
Measured software latency. It represents the amount of time it takes Motive to process each frame of captured data. This includes the time taken for reconstructing the 2D data into 3D data, labeling and modeling the trackable assets, displaying in the viewport, and other processes configured in Motive.
System
Available only on Ethernet Camera systems (Prime series and Slim13E). Measured total system latency. This is the time measured from the middle of the camera exposures to when Motive has fully solved all of the tracking data.
Streaming
The rate at which the tracking data is streamed to connected client applications.
Cameras
Available only on Ethernet Camera systems (Prime series or Slim 13E). Average temperature, in Celsius, on the imager boards of the cameras in the system.
Important software notifications will be reported at the right corner of the control deck. Click on the to view the message. Only the important configuration notification will be reported here. Software status messages are reported on the pane.
